Suzuki GA413, Service Manual

Page: 792 / 1246

NOTE:
D
If abnormality or malfunction lies in two or more areas, mal-
function indicator lamp indicates applicable codes three
times each.
And flashing of these codes is repeated as long as diagno-
sis terminal is grounded and ignition switch is held at ON
position.
D
Take a note of diagnostic trouble code indicated first.
4) After completing the check, turn the ignition switch OFF position
and disconnect service wire from monitor coupler.
DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE
[Using SUZUKI scan tool]
1) Connect SUZUKI scan tool (Tech-1) to data link connector in the
same manner as when making this connection for DTC check.
2) Turn ignition switch ON.
3) Erase DTC and pending DTC according to instructions dis-
played on scan tool. Refer to scan tool operator’s manual for fur-
ther details.
4) After completing the clearance, turn ignition switch off and dis-
connect scan tool from data link connector.
NOTE:
DTC and freeze frame data stored in ECM memory are also
cleared in following cases. Be careful not to clear them be-
fore keeping their record.
D
When power to ECM is cut off (by disconnecting battery
cable, removing fuse or disconnecting ECM connectors)
D
When the same malfunction (DTC) is not detected again
during 40 engine warm-up cycles.
[Without using SUZUKI scan tool]
1) Turn the ignition switch OFF position.
2) Disconnect battery negative cable for specified time below to
erase diagnostic trouble code stored in ECM memory and re-
connect it.
Time required to erase DTC:
6-16 ENGINE GENERAL INFORMATION AND DIAGNOSIS
GA413
supple
Ambient temperature Time to cut power to ECM
Over 0
_
C (32
_
F) 30 sec. or longer
Under 0
_
C (32
_
F)
Not specifiable.
Select a place with higher than
0
_
C (32
_
F) temperature.