Suzuki GA413, Service Manual

Page: 401 / 1246

6) Mark the location of clamps on fuel pipes, so that clamps can
be reinstalled to where they were.
7) Remove pipes with clamp from vehicle.
8) Remove clamp from pipes.
INSTALLATION
1) Install new clamps to marked location on pipes.
2) Install pipes with pipe clamps to vehicle.
1. Floor
2. Bolt
3. Clamp
4. Push
3) Connect fuel hoses and pipes to each pipe.
CAUTION:
When connecting joint, clean outside surfaces of
pipe where joint is to be inserted, push joint into
pipe till joint lock clicks and check to ensure that
pipes are connected securely, or fuel leak may oc-
cur.
When connecting hoses to rear end of pipes, se-
cure them with clamps referring to 6C-4. And for
hoses to front end of pipes, refer to “Engine” sec-
tion.
4) Install air cleaner case.
5) Install ABS hydraulic unit and bleed air from brake line (if
equipped with ABS).
6) With engine “OFF” and ignition switch “ON”, check for fuel
leaks.
FUEL FILLER CAP
Remove cap, and check gasket for even filler neck imprint, and de-
terioration or any damage. If gasket is in malcondition, replace cap.
NOTE:
If cap requires replacement, only a cap with the same features
should be used. Failure to use correct cap can result in critical
malfunction of system.
1. Fuel filler cap
2. Gasket
6C-6 ENGINE FUEL