Suzuki GA413, Service Manual

Page: 339 / 1246

Embossed marks are provided on each camshaft housing,
indicating position and direction for installation.
Install housing as indicated by these marks.
As camshaft housing No. 1 retains camshaft in proper posi-
tion as to thrust direction, make sure to first fit No. 1 housing
to No. 1 journal of camshaft securely.
Indicates position from timing
belt side. Install in numerical
order starting from timing belt
side.
Indicates direction of housing.
Install so that arrow is directed
toward timing belt side.
After applying engine oil to housing bolts, tighten them tem-
porarily first. Then tighten them by following sequence as in-
dicated in figure.
Tighten a little at a time and evenly among bolts and repeat
tightening sequence three to four times before they are
tightened to specified torque.
Tightening Torque
(a): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
9) Install camshaft oil seal.
After applying engine oil to oil seal lip, press-fit camshaft oil
seal till oil seal surface becomes flush with housing surface.
1. Camshaft oil seal
10) Install camshaft timing belt pulley to camshaft while fitting pin
on camshaft into slot at “E” mark.
1. Camshaft timing belt pulley 2. Dwell pin
11) Using special tool, tighten pulley bolt to specified torque.
Tightening Torque
(a): 60 N
.
m (6.0 kg-m, 43.5 lb-ft)
Special Tool
(A): 09917-68221
12) Install belt tensioner, timing belt, outside cover, crankshaft
pulley and generator belt as previously outlined.
ENGINE MECHANICAL 6A-33