Suzuki GA413, Service Manual

Page: 521 / 1246

DIAGNOSIS
BATTERY
VISUAL INSPECTION
Check for obvious damage, such as cracked or broken case or
cover, that could permit loss of electrolyte. If obvious damage is
noted, replace battery. Determine cause of damage and correct as
needed.
HYDROMETER TEST
The direct method of checking the battery for state of charge is to
carry out a high rate discharge test, which involves a special pre-
cise voltmeter and an expensive instrument used in the service
shops, but not recommendable to the user of the vehicle.
At 20
_
C of battery temperature (electrolyte temperature):
— The battery is in FULLY CHARGED STATE it the electrolyte
S.G. is 1.280.
— The battery is in HALF CHARGED STATE if the S.G. is 1.220.
— The battery is in NEARLY DISCHARGED STATE if the S.G. is
1.150 and is in danger of freezing.
As the S.G. varies with the temperature, if battery temperature is
not at 20
_
C (68
_
F), you have to correct your S.G. reading (taken
with your hydrometer) to the value at 20
_
C (68
_
F) and apply the
corrected S.G. value to the three-point guide stated value.
For the manner of correction, refer to the graph showing the rela-
tion between S.G. value and temperature at the left.
HOW TO USE THE TEMPERATURE-CORRECTED
STAGE-OF-CHARGE GRAPH
Suppose your S.G. reading is 1.28 and the battery temperature is
–5
_
C (23
_
F). Locate the intersection of the –5
_
C line and the 1.28
S.G. line.
The intersection is within the “A” zone (shaded area in the graph)
and that means CHARGED STATE.
To know how much the battery is charged, draw a line parallel to
the zone demarcation line and extend it to the right till it meets with
the percentage scale. In the present example, the line meets at
about 85% point on the percentage scale. Therefore, the battery
is charged up to the 85% level.
6H-6 CHARGING SYSTEM