Suzuki GA413, Service Manual

Page: 172 / 1246

2) Install shock absorber lower mounting bolt.
3) Remove floor jack from rear axle housing.
4) Install parking brake cable clamp bolt and brake flexible hose
E-ring.
5) Install lateral rod to vehicle body .
NOTE:
Nut should not be tightened.
6) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque for wheel nuts
85 N·m (8.5 kg-m, 61.5 lb-ft)
7) Lower hoist and vehicle in non-loaded condition, tighten ab-
sorber lower mounting nut and lateral rod left mounting nut to
specified torque.
Tightening Torque
(a): 80 N·m (8.0 kg-m, 58.0 lb-ft)
1. Shock absorber
2. Lateral rod
BUMP STOPPER AND SPRING UPPER SEAT
(COIL SPRING TYPE)
REMOVAL
1) Removal coil spring. For details, refer to steps 1) to 8) of COIL
SPRING REMOVAL.
2) Remove spring upper seat.
3) Remove bump stopper by using special tool.
Special Tool
(A): 09941-66010
1. Spring upper seat
2. Bump stopper
INSTALLATION
1) Install bump stopper.
NOTE:
Before installing bushing, apply soap water on it.
For proper installing direction of spring upper seat, refer
to figure at left.
2) Install spring upper seat.
3) Install coil spring. For details, refer to steps 1) to 7) of COIL
SPRING INSTALLATION.
Up side
1. Spring upper seat
2. Bump stopper
3E-8 REAR SUSPENSION