Suzuki GA413, Service Manual

Page: 707 / 1246

AIR BAG SYSTEM 10B-13
DTC TABLE
DTC
“AIR BAG” warning lamp
flashing pattern
Diagnosis DTC
NO. MODE
Diagnosis
– 12 Normal –––––
B1015 15 Resistance high
B1016 16
Passenger air
bag circuit
Resistance low
B1018 18
bag circuit
(if equipped)
Short to ground
B1019 19 Short to power circuit
B1021 21 Resistance high
Diagnose
trouble accord-
B1022 22
Driver air bag
Resistance low
trouble accord-
ing to diagnostic
B1024 24
g
circuit
Short to ground
flow table corre-
sponding to
B1025 25 Short to power circuit
s onding to
each code No.
B1032 32
Power source
voltage
Too low
B1051 51 Frontal crash detected
B1071 71
SDM
Internal fault
B1013 13
Specifications different between
air bag system and SDM
NOTE:
When 2 or more codes are indicated, the lowest numbered code will appear first.
If a code not listed on the table is displayed, then the SDM is faulty.
Current DTC and history DTC can be identified by lighting and flashing of “AIR BAG” warning lamp as
follows.
Current DTC is set.
(Abnormality exists at present.)
History DTC is set only. (Faulty condi-
tion occurred once in the past but nor-
mal condition is restored at present.)
“AIR BAG” warning lamp
after ignition switch ON
Flashing 6 times and turns on. Flashing 6 times and turns off.
“AIR BAG” warning lamp
when grounding diagnosis
switch
Current DTC is displayed. History DTC is displayed.
However, if a multiple number of DTC’s are set an even one of them is a current DTC, “AIR BAG” warning
lamp remains on after ignition switch is turned ON. Therefore, it is not possible to identify any of them
as to whether it is a current one or a history one. (But use of SUZUKI scan tool will make identification
possible.)