Suzuki GA413, Service Manual

Page: 766 / 1246

ITEM 6-10
Differential Oil (Front for 4WD and Rear)
Inspection
1) Check differential for evidence of oil leakage.
Repair leaky point if any.
2) Make sure that vehicle is placed level for oil level check.
3) Remove level plug of differential and check oil level.
Oil level can be checked roughly by means of level plug hole.
That is, if oil flows out of level plug hole or if oil level is found up
to hole when level plug is removed, oil is properly filled.
If oil is found insufficient, pour specified amount of specified oil.
1. Drain plug
2. Filler/level plug
CAUTION:
Specified gear oil must be used for differential.
4) Tighten level plug to specified torque.
Refer to OIL CHANGE in SECTION 7E and/or 7F.
Change
Change differential oil with new specified oil. Refer to OIL
CHANGE in SECTION 7E and/or 7F.
[A]
[B]
[A]: Front differential for 4WD
[B]: Rear differential
ITEM 6-13
Drive Shaft Boot Inspection (4WD)
Check drive shaft boot (wheel side and different side) (1) for leak-
age, detachment, tear or any other damage.
Replace boot as necessary.
2. Drive shaft
Propeller Shaft(s) Inspection
1) Check universal joint, constant velocity joint (4WD) and spline
of propeller shaft for rattle and damage. If rattle or damage is
found, replace defective part with a new one.
2) Check propeller shaft joint bolts for tightness, and retighten
them as necessary.
Refer to Section 4B or 4B1 for tightening torque.
MAINTENANCE AND LUBRICATION 0B-7
GA413
supple