Suzuki GA413, Service Manual

Page: 1086 / 1246

“ A ” : Fill grease (Yellow grease included in spare part)
60 – 80 g (2.1 – 2.8 oz)
“ B ” : Fill grease (Black grease included in spare part)
60 – 80 g (2.1 – 2.8 oz)
Forward rotation
Wheel side
Differential
side
4A-8 FRONT DRIVE SHAFT
8) Apply grease to inside of outer race.
9) Insert cage into outer race and fit snap ring (1) into groove of
outer race (2).
CAUTION:
Position opening of snap ring
“ c ” so that it will not be
lined up with a ball.
10) Fill up inside of outer race with grease again and fit boot to outer
race.
After fitting boot, insert screwdriver into boot on outer race side
and allow air to enter boot so that air pressure in boot becomes
the same as atmospheric pressure.
11) When fixing boot band, note the direction of band and adjust
the boot position so that measurements “ d ” become as speci-
fied.
Length “ a ” : 140.8 – 150.8 mm (5.53 – 5.93 in.)
CAUTION:
D
To prevent any problem caused by washing solution,
do not wash joint boots. Degreasing of those parts
with cloth is allowed.
D
To ensure full performance of joint as designed, be
sure to distinguish between two types of grease in re-
pair set and apply specified volume to respective
joint, i.e. yellow grease to wheel side joint and black
one to DOJ.
D
Bend each boot band against forward rotation.
D
Do not squeeze or distort boot when fastening it with
bands.
Such distorted boot may reduce its durability.