Suzuki GA413, Service Manual

Page: 1087 / 1246

More than 0.5 mm
2, “ A ” , (a)
1, “ A ” , (a)
FRONT DRIVE SHAFT 4A-9
INSTALLATION
CAUTION:
D
To avoid excessive expansion of boot and consequential
disconnection of joint in boot, do not pull differential side
joint housing.
D
Protect oil seals and boots from any damage, preventing
them from unnecessary contact while installing drive
shaft.
D
Do not hit joint boot with hammer. Inserting joint only by
hands is allowed.
D
Make sure that differential side joint is inserted fully and
its snap ring is seated as it was.
Install drive shaft assembly by reversing removal procedure and
noting following points.
D
Clean front wheel bearing oil seal and then apply grease.
Replace it if required.
Grease: 99000-25010
D
Tighten each bolt and nut to the specified torque.
Tightening Torque
(a): 23 N
.
m (2.3 kg-m, 16.5 lb-ft)
(b): 90 N
.
m (9.0 kg-m, 65.0 lb-ft)
(c): 60 N
.
m (6.0 kg-m, 43.5 lb-ft)
(d): 43 N
.
m (4.3 kg-m, 31.5 lb-ft)
(e): 85 N
.
m (8.5 kg-m, 61.5 lb-ft)
(f): 175 N
.
m (17.5 kg-m, 127.0 lb-ft)
(g): 85 N
.
m (8.5 kg-m, 61.5 lb-ft)
D
Apply sealant to drain plug (1) and level / filler plug (2) for front dif-
ferential and front differential with oil as specified. (Refer to SEC-
TION 7E.)
“ A ” : Sealant 99000-31110