Suzuki GA413, Service Manual

Page: 908 / 1246

5) Disconnect electric connector from TP sensor (1), MAP sensor
(3) and IAC valve (2).
6) Remove throttle body (4) from intake manifold.
7) Disconnect engine coolant hoses from throttle body.
DISASSEMBLY
NOTE:
While disassembling and assembling throttle body, use spe-
cial care not to deform levers on throttle valve shaft or cause
damage to any other parts.
1) Remove TP sensor, MAP sensor and IAC valve from throttle
body.
CLEANING
Clean throttle body bore (1) and idle air passage (2) by blowing
compressed air.
NOTE:
TP sensor, MAP sensor, idle air control valve or other compo-
nents containing rubber must not be placed in a solvent or
cleaner bath. A chemical reaction will cause these parts to
swell, harden or get distorted.
REASSEMBLY
1) Install IAC valve to throttle body referring to “IAC valve Installa-
tion” in this section.
2) Install TP sensor to throttle body referring to “TP sensor Installa-
tion” in this section.
3) Install MAP sensor to throttle body referring to “MAP sensor
Installation” in this section.
INSTALLATION
1) Clean mating surfaces and install throttle body gasket to intake
manifold.
Use new gasket.
6E-16 ENGINE AND EMISSION CONTROL SYSTEM
GA413
supple