Shibaura ST330, Workshop Manual

Page: 84 / 250

74
2. DISASSEMBLY, INSPECTION AND REASSEMBLY OF CLUTCH
（
Refer to 1
－
5, Removal of outside, for the clutch case separating method.
）
1
）
Disassembling procedure
（
1
）
Release bearing
・
Release hub
・
Clutch shaft
・
Clutch fork
① Remove the return spring and extract the release hub and bearing together frontward.
② Disconnect the wire and drive out the spring pin.
③ Remove the snap ring, extract the clutch shaft leftwards, and take out the clutch fork from the case.
For Manual Transmission
326Y
2
）
Inspection and service
(1) Pressure plate ass’y
① Wear of lever (fork end) to be in contact with the
release bearing.
② If the friction surface is deflected, scratched or
worn out unevenly, correct with sand paper or
replace.
For HST Transmission
327Y
329Y
330Y