Shibaura ST330, Workshop Manual

Page: 130 / 250

120
( 3) Differential support
・
Differential ass'y
① Remove the right and left differential supports, 1 .
NOTE:
1. Though the right and left differential supports are
the same, number and thickness of shims are
different. Keep them independently.
2. Remove the differential lock clutch , 4, on the left
side.
②
Remove the differential ass'y, 5.
(4) Shifter rod
・
Shifter fork
(For range gear transmission)
①
Remove the safety switch, 11, seal washers, 10,
shim, 14, and steel ball, 13, from the housing.
②
Drive out the roll pins, 1, from shifter fork.
shifter rod, 3, and change lever, 12.
③
Extract the shifter rod, 3, front-wards
NOTE
：
・ Steel balls , 6, come out from housing when remove the
shifter rod, 3. Take care not to miss it.
・ The steel balls, 6 and 13, are different size which small
size ball, 13, is installed to the safety switch, 11, side.
④ Remove the shifter fork, 2.
⑤ Remove the shift arm, 4 , (after removing the drive
pinion.)
⑥ Remove spring, 5 , from the housing.
406Y
407Y
1. Differential support
2. Shim : 0.1 t
: 0.3 t
: 0.5 t
3. Bolt
4. Differential lock clutch (left only)
5. Differential ass’y
1. Roll pin
2. Shifter-fork
3. Shifter rod; range
4. Shift arm
；
range
5. Spring
6. Steel ball (
φ
8.73)
7. O-ring (P14)
8. Plate
9. Bolt (M3
×
16)
10. Seal washer
11. Safety switch
12. Change lever
13. Steel ball (
φ 7.94)
14. Shims (t=0.5mm)