Shibaura ST330, Workshop Manual

Page: 239 / 250

227
2. Disassembly
Reference Figure 6 14Y.
NOTE
：
1. B efo re d isassembling starter, b e sure to
put match marks a t two loca tions
(switch and yo ke) so that an y po ssible
mistake can be avo id ed.
2. D o not clamp yoke i n a vise or strike it
with a hamm er du ring repair opera tions.
Permanent magn ets a ttached to yoke
could be broken and yoke d ented or
deformed if mishandled.
(1) R emo ve switch terminal nu t (l) and
disconnect connecting wire (2).
Remove screws (3) securing sw itch and
remove sw itch and plung er (4 ).
(2) R emo ve brush holder securing screws
(5) and thro ugh bolts (6 ).
Remove rear bracket (7) but do not
remove bru sh ho ld er (8).
(3) I n stall a socket (ou ter diameter 30mm)
on th e armature commutator, see Figu re
613Y .
Th en slide the b rush holder (8) onto th e
so cket.
Leave th e socket in position in the
brush hold er for insp ection and
reassemb ly. So cket
613Y
(4) S lid e y oke (9 ) away from front bracket
(10).
(5) R e mov e ar mature ( 11) and b all (12).
Do not lose ball when removing the
armature.
614Y