Shibaura ST330, Workshop Manual

Page: 93 / 250

83
7
）
Drive shaft (4WD)
Drive out the drive shaft (4WD) front-wards and
remove the slide gear.
1. Drive shaft
2. Slide gear
3. Bearing (6303)
8
）
Shifter rod
・
Shifter fork (4WD)
① Drive out the shifter rod rear-wards and remove
the shifter fork.
NOTE
：
When the shifter rod pulled out, a steel ball and spring
come out from in the shifter fork.
Be careful not to miss them.
② Drive out the spring pin and remove the change
lever.
③ Remove the shift arm from the inside of the
housing.
9
）
Drive Shaft
・
Retainer
・
Oil seal
（
Remove it from clutch housing
）
①
Remove the snap ring (
φ
30) and take out the
fixed gear from drive shaft.
② Remove the snap ring ( φ 52) from in the retainer
and drive out the drive shaft and bearing to
rear-ward.
③
Remove bolts and retainer from rear of clutch
housing.
④ If necessary remove the oil seal from in the
retainer and clutch housing.
350Y
351Y
352Y