Shibaura ST330, Workshop Manual

Page: 92 / 250

82
4
）
Reverse gear shaft
①
Remove the snap ring (
φ
47) from in the
housing.
②
Drive out the reverse gear shaft together with the
bearing on the front side
to front-wards while
holding the counter gear A.
③
Remove the bearing from the shaft if necessary.
Remove the bearing and snap ring ( φ 52) from the
case.
1. Snap ring (
φ
47)
2. Bearing (6204)
3. Reverse gear shaft
4. Counter gear A (reverse idler)
5. Bearing (6304)
6. Snap ring (
φ
52)
5
）
Counter shaft
① Remove the snap ring ( φ 62) from in the housing.
②
Drive out the counter shaft front-wards and
remove the fixed gears (3 pcs), collar (1 pc.) and
bearing.
6
）
PTO counter shaft
① Remove the snap ring ( φ 32), collars, thrust
washers, 4WD counter gear and needle bearings
from PTO counter shaft.
②
Remove the snap ring (
φ
55) fixing the bearing
(6006) in the middle of the housing.
③ Driving out the shaft rearwards, remove the
bearing (6205) and counter gear at the shaft end.
④ Remove 2 snap rings ( φ 30) and bearing (6006)
from the shaft if necessary.
347Y
348Y
349Y
7. Fixed gear A (main: 3)
8. Fixed gear A (main: 2)
9. Collar
10. Fixed gear A (R)
11. Bearing (6205)
12. Snap ring (
φ
52)
1. Bearing
2. Fixed gear A
3. Snap ring (
φ 30)
4. Snap ring (
φ
62)
5. Bearing (6206)
6. Counter shaft
1. PTO counter shaft
2. Snap ring ( φ 55)
3. Bearing (6006)
4. Snap ring ( φ 30)
5. Fixed gear
6. Bearing (6205)
7. Snap ring ( φ 52)
8. Snap ring (
φ
32)
9. Collar
10. Thrust washer
11. 4WD counter gear
12. Needle bearings
13. Collar
14. Thrust washer