Shibaura ST330, Workshop Manual

Page: 139 / 250

129
②
Remove the shifter rod fixing bolt, 7, and drive out
the rod, 5, rear-wards.
NOTE ：
Be careful since a steel ball, 3, comes out from the
shifter fork, 2.
③
Take out the shifter fork, 2.
④ Take out the seal cover, 13, at the rear side of the
case and remove the snap ring (
φ
52), 12.
⑤
Drive out the shaft, 11, rearwards together with the
bearing, 9, and take out the slide gear, 10.
⑥
Takeout the bearing, 9, and oil seal, 8, from the
case if necessary.
436Y
1. Mid PTO gear case
2. Shifter fork
3. Steel ball
4. Spring
5. Shifter rod
6. O-ring (P11)
7. Bolt
8. Oil seal
9. Bearing (6205)
10. Slide gear
11. PTO shaft
12. Snap ring (
φ
52)
13. Seal cover
14. Cover ； cap
15. Bolt
16. Bolt
17. Spring washer