Shibaura ST330, Workshop Manual

Page: 136 / 250

126
(
4) Shifter rod
・
Shifter fork
（
Range transmission
）
①
Drive out the roll pins, 1, from shifter fork, 2,
shifter rod, 3, and change lever, 12.
②
Pull out the shifter rod, 3, front-wards.
NOTE
：
Two steel balls, 6, come out from the housing. Be
careful not to miss them.
③ Remove the shifter fork, 2.
④ Remove the plate, 8, and extract the shift arm, 4,
inwardly (after remove the drive pinion).
⑤ Remove the switch ass’y, 11, shim, 14, seal
washers, 10, and spring, 5, from the housing.
(5) Drive pinion
①
Straighten the flange of the lock nut, 5, and
untighten lock nut.
② Pulling out the drive pinion, 1, rearwards, remove
the fixed gear (4WD), 8, snap rings (2 pcs), 6, and
slide gear, 7, (Range transmission).
③
Pilling out the lock nut, 5, taper reller bearings, 4,
and shims, 3.
(6) PTO counter shaft
①
Remove the snap ring (
φ
25), 1, from the shaft, 7,
and remove the collar, 2, thrust washers, 3, counter
gear, 5, (4WD), needle bearings (2 pcs), 4, and
collar, 6.
②
Drive out the shaft, 7, and bearing, 8, front-wards
together and remove the joint, 9, and snap ring, 10,
on the rear side.
426Y
427Y
428Y
1. Drive pinion
2. Bearing (6205)
3. Shim (t ＝ 0.1, 0.2)
4. Taper roller
bearing
5. Lock nut
6. Snap ring (
φ
28)
7. Slide gear
（ Range transmission ）
8. Fixed gear (4WD)
1. Roll pin
2. Shifter fork
3. Shifter rod
4. Shift arm
5. Spring
6. Steel balls ( φ 8.73)
7. O-ring (P14)
8. Plate
9. Bolt
10. Seal washers
11. Switch
12. Change lever
13. Steel ball ( φ 7.94)
14. Shim (t=0.5mm)
1. Snap ring ( φ 25)
2. Collar
3. Thrust washer
4. Needle bearing
5. Counter gear
(4WD)
6. Collar
7. PTO counter shaft
8. Bearing
9. Coupling
10. Snap ring ( φ 22)