Shibaura ST330, Workshop Manual

Page: 101 / 250

91
(4)
Fixed gear A
① Drive out the fixed gear A rear-wards together
with the bearing.
(5) Drive shaft
（
4WD
）
① Break and remove the oil seal and remove the snap
ring
（φ
42
）
.
②
Slide out the shaft front-wards together with the
bearing
（
6004
）
and take out the slide gear.
③
Remove the bearing (6303) from rear of housing.
④ If necessary, remove the snap ring （φ 42 ） and
bearing (6004 uu) from bottom of clutch housing.
(6) Shifter rod
・
Shifter fork
（
4WD
）
①
Extract the shifter rod rear-wards and remove the
shifter fork.
NOTE
：
When extracting the rod, steel ball and spring come out
of the fork.
Take care for them not to miss.
② Drive out the spring pin and remove the change
lever.
③ Remove the shift arm from the inside of the case.
366Y
367Y
368Y
1. Shifter fork
2. Spring
3. Steel ball
4. Shift arm
5. Shift rod
6. Snap ring
（ E-shaped ）
7. Change lever
8. Spring pin
9. O-ring
10. Shift guide
11. Seal washer