Shibaura ST330, Workshop Manual

Page: 134 / 250

124
(8) Bearing support
：
9
×
3One speed PTO only
① Remove the seal cover, 4, bearing support, 3, snap
ring, 2, and bearing (6206NR), 1, from housing.
NOTE
：
Since the bearing support is installed horizontally with
snap ring and therefore should be taken at the time
of reassembly.
1. Bearing
（
6206NR
）
2. Snap ring （φ 62 ）
3. Bearing support
4. Seal cover
(9) PTO Shifter rod.
①
Drive out the roll pin, 14, from the PTO shifter
fork.
② Remove the bolt, 1, spring, 2, and steel ball, 3,
from the left side of the housing.
③ Remove the PTO safety switch, 4, and pin, 5, from
the left of the housing.
④ Drive out the roll pin, 7, from the change lever, 6,
and remove the change lever, 6.
⑤
Remove the bolt, 8, and plate, 9.
⑥ Remove the shift arm, 10, inward from housing.
⑦
Remove the shifter rod, 12, from housing.
(10) Bracket
・
Filter
① Remove the filters and bracket from housing.
(11) Differential ass’y
① Remove 8 bolts tightening the bevel gear and
separate the differential cage.
②
Remove the knock pin and take out the gears,
thrust washers and shafts in the differential cage.
NOTE
：
The factory installed ring gear bolts are coated with a
thread sealant on assembly and should not be reused.
On installation, use new bolts with locking plates.
420Y
421Y
422Y
2
）
Inspection
Refer to the description of “ Transmission 2 for HST ” for inspections.
3
）
Reassemble
Refer to the description of “ Transmission 2 for HST ” for reassembly.