Rohde & Schwarz 1332.4500.22, User Manual

Page: 803 / 1476

Command Reference
R&S
®
ZNA
803 User Manual 1178.6462.02 ─ 12
Manual operation: See "Port Sequence" on page 579
CALCulate:FMODel:ISD<Ph_pt>:PORT:SKIP <String>
Tells the ISD tool which ports (in the measured DUT + Test Fixture file) shall be skip-
ped when the tool is run.
Equivalent to using the
ports_to_skip
batch mode parameter of the ISD tool with a
list of (positive) port numbers.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<String> The port numbers, separated by blanks (e.g. '1 3 4').
Manual operation: See "Ports to Skip (manual)" on page 580
CALCulate:FMODel:ISD<Ph_pt>:PORT:SKIP:LEFT
CALCulate:FMODel:ISD<Ph_pt>:PORT:SKIP:NONE
CALCulate:FMODel:ISD<Ph_pt>:PORT:SKIP:RIGHt
Tells the ISD tool which ports (in the measured DUT + Test Fixture file) shall be skip-
ped when the tool is run.
●
...:LEFT : skip the ports on the left (according to the port order specified using
CALCulate:FMODel:ISD<Ph_pt>:PORT:ORDer
)
●
...:NONE : do not skip any ports
●
...:RIGHt : skip the ports on the right (according to the port order specified using
CALCulate:FMODel:ISD<Ph_pt>:PORT:ORDer
)
Equivalent to setting the
ports_to_skip
batch mode parameter of the ISD tool to -1,
0 or -2, respectively.
Use
CALCulate:FMODel:ISD<Ph_pt>:PORT:SKIP
to define an arbitrary set of
ports to be skipped.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Manual operation: See "Ports to Skip" on page 579
CALCulate:FMODel:ISD<Ph_pt>:RUN:RUN
Runs the ISD tool.
Before executing this command, make sure that
●
the test coupon measurement (using
CALCulate:FMODel:ISD<Ph_pt>:
COUPon:MEASure:OPEN
and
CALCulate:FMODel:ISD<Ph_pt>:COUPon:
MEASure:SHORt
for 1xShort,
CALCulate:FMODel:ISD<Ph_pt>:
COUPon:MEASure
otherwise) finished successfully, or the test coupon data were
SCPI Command Reference