Rohde & Schwarz 1332.4500.22, User Manual

Page: 468 / 1476

GUI Reference
R&S
®
ZNA
468 User Manual 1178.6462.02 ─ 12
Start Cal Sweep
Start the calibration sweep for the selected port and power calibration settings and
close the dialog. The calibration is performed as described in
"Calibration procedure"
on page 161. No additional calibration settings are needed.
Remote command:
[SENSe<Ch>:]CORRection:POWer<PhyPt>:ACQuire
[SENSe<Ch>:]CORRection:POWer:DATA
[SENSe<Ch>:]CORRection:POWer:DATA:PORT<PhyPt>
Power Cal Dialog (Source Flatness)
In "Source Flatness" mode, the "Power Cal" dialog guides you through a source power
calibration of a single port.
The dialog shows the selected source port with its current cal power settings (see
Chapter 6.11.3.2, "Cal Power Config Dialog" , on page 489).
A circuit diagram visualizes the calibration setup, which depend on the selected Pwr
Cal Method .
●
"Ref. Receiver": connect a DUT or a Match to the related source port
●
"Power Meter": connect a power meter to the related source port
Access: Power Cal Wizard > "Source Flatness"
Background information
Refer to Chapter 5.5.6.1, "Source Power Calibration" , on page 159 and Chap-
ter 5.5.7.3, "Combining SMARTerCal with Scalar Power Calibration" , on page 166.
left = "Ref. Receiver" Pwr Cal Method
right = "Power Meter" Pwr Cal Method
Cal Softtool