Rohde & Schwarz 1332.4500.22, User Manual

Page: 1214 / 1476

Command Reference
R&S
®
ZNA
1214 User Manual 1178.6462.02 ─ 12
IAMPlitude | IPHase
Amplitude | Phase imbalance sweep
Only available in
True Differential Mode (
SOURce<Ch>:TDIF[:STATe] ON
)
The sweep properties can be set using SOURce:TDIFferential...
commands.
*RST:
LINear
Example: *RST
Reset the analyzer, activating a linear frequency sweep.
SWE:TYPE LOG
Change to a logarithmic frequency sweep, resetting the stimulus
values of the sweep points.
Manual operation: See "Lin Freq" on page 418
[SENSe<Chn>:]SWEep:SRCPort <Port>
Sets/gets the source port for the stimulus signal. The setting acts on the active trace.
The effect of the drive port selection depends on the measurement parameter associ-
ated to the active trace:
●
If an S-parameter S
<out><in>
is measured, the second port number index
<in>
(input
port of the DUT = drive port of the analyzer) is set equal to the selected drive port:
Drive port selection affects the measured quantity.
●
If a wave quantity or a ratio is measured, the drive port is independent of the mea-
sured quantity:
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Port> Logical port number
*RST:
1
Example:
CALC4:PAR:SDEF "Ch4Tr1", "A1"
Create channel 4 and a trace named "Ch4Tr1" to measure the
wave quantity a
1
. The trace automatically becomes the active
trace.
SENS4:SWE:SRCP 2
Select drive port 2 for the active trace.
CALC4:PAR:MEAS? "Ch4Tr1"
Query the measurement result for "Ch4Tr1". The response is
'A1D2SAM'
.
8.3.14.26 [SENSe:]UDSParams...
The
[SENSe:]UDSParams...
commands are related to Redefined S-Parameters .
SCPI Command Reference