Command Reference
R&S
®
ZNA
757
User Manual 1178.6462.02 ─ 12
Note
●
Importing data is only supported in single sweep mode (
OFF
)
●
Before importing data, the channel must be configured with the same settings that
were used during export (user calibration, balanced port configuration, stimulus
axis etc.).
●
After importing data, "downstream" parameters in the data flow can be changed
and their effect is shown directly
●
Any request for new data from the hardware (Restart Sweep in single sweep mode
or switching to continuous sweep mode) discards imported data and switches back
the display to measured data
Suffix:
<Ch>
.
Channel number
Parameters:
<Format>
SDATa | FSIData
SDATa
Output as unformatted trace data; see
. Query only.
FSIData
Output or input at "Fixture Simulation Input" data access point.
<Data>
Trace data either in ASCII or block data format, depending on
the current
The column order must match the one used during export.
Example:
Suppose that a TOSM calibration for ports 1 and 2 is active in
channel no. 1.
CALCulate:DATA:CALL:CATalog?
Query the traces available for
CALCulate<Ch>:DATA:CALL?
.
The response is
'S11,S12,S21,S22'
.
CALCulate:DATA:CALL? SDATa
Return the complex response values of all traces. The traces in
the catalog list are read one after another: The response array
contains n (number of points) pairs of real and imaginary values
for S
11
, followed by n pairs of values for S
12
, S
21
, and S
22
.
CALCulate<Ch>:DATA:CALL:CATalog?
Returns all traces which are available for
in channel
no.
<Ch>
. The response is a string parameter with all S-parameter traces in the current
channel or in the active system error correction; see example.
Suffix:
<Ch>
.
Channel number
Example:
See
Usage:
Query only
SCPI Command Reference
