Rohde & Schwarz 1332.4500.22, User Manual

Page: 1187 / 1476

Command Reference
R&S
®
ZNA
1187 User Manual 1178.6462.02 ─ 12
Parameters:
<Boolean> ON | OFF - activates or deactivates the measurement in sweep
segment
<Seg>
.
*RST: ON
Example: SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1 using
default settings.
SEGM OFF
Disable the measurement in the created sweep segment.
Manual operation: See "Table Columns" on page 425
[SENSe<Ch>:]SEGMent<Seg>:ADD
Inserts a new sweep segment using default channel settings ("Insert New Segment").
The added segment covers the frequency interval between the maximum frequency of
the existing sweep segments and the stop frequency of the entire sweep range.
Tip: Use
[SENSe<Ch>:]SEGMent<Seg>:INSert
to create a segment with specific
channel settings.
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number. Segment numbers must be sequential.
If n segments exist already, the added segment must have the
segment number n+1.
Example: SEGM:INS 1MHZ, 1.5MHZ, 111, -21DBM, 0.5S, 0,
10KHZ
Create a sweep segment with a sweep range between 1.0 MHz
and 1.5 MHz.
SEGM2:ADD
Create a second sweep segment. The frequency range of the
second segment will be between 1.5 MHz and the maximum fre-
quency of the analyzer.
Usage: Event
Manual operation: See "Add / Insert / Delete / Delete All" on page 426
[SENSe<Ch>:]SEGMent<Seg>:BWIDth[:RESolution] <ResBandwidth>
Defines the IF bandwidth of the analyzer (measurement bandwidth) in sweep segment
no.
<Seg>
. Values between 1 Hz and 1.5 MHz can be set. Option R&S ZNA-K17 ena-
bles IF bandwidths up to 10 MHz (see Chapter 5.7.8, "Increased IF Bandwidth
30 MHz" , on page 218).
Bandwidths can be set in 1
–
1.5
–
2
–
3
–
5
–
7 steps. The analyzer rounds up any
entered value between these steps and rounds down values exceeding the maximum
bandwidth.
SCPI Command Reference