Rohde & Schwarz 1332.4500.22, User Manual

Page: 1313 / 1476

Command Reference
R&S
®
ZNA
1313 User Manual 1178.6462.02 ─ 12
RESTart
Restart the firmware.
Example: SYST:SHUT
Switch the analyzer to standby state.
Usage: Setting only
SYSTem:SOUNd:ALARm[:STATe] <Boolean>
SYSTem:SOUNd:STATus[:STATe] <Boolean>
These commands switch alarm or status sounds on or off.
Parameters:
<Boolean> ON | OFF
*RST:
ON
Example: SYST:SOUN:ALAR OFF; STAT OFF
Switch alarm and status sounds off.
Manual operation: See "Sounds " on page 669
SYSTem:TIME <Hours>, <Minutes>, <Seconds>
The command queries or defines the instrument's current time setting.
The setting command requires administrator rights; refer to Chapter 11.1.1, "Windows
Operating System" , on page 1411.
Parameters:
<Hours> Range: 0...23
<Minutes> Range: 0...59
<Seconds> Range: 0...59
Example: SYST:TIME?
Response:
12,0,0
- it is precisely 12 pm.
SYSTem:TRESet[:STATe] <Boolean>
Defines the behavior of the
INITiate<Ch>[:IMMediate][:DUMMy]
and
INITiate[:IMMediate]:ALL
.
Parameters:
<Boolean> OFF (0)
Previous trace data are preserved.
ON (1)
Previous trace data are deleted.
This is a global setting that is not affected by an instrument
reset. Factory default is OFF (0).
Manual operation: See "Restart: Set all Traces to 0" on page 670
SCPI Command Reference