Rohde & Schwarz 1332.4500.22, User Manual

Page: 1195 / 1476

Command Reference
R&S
®
ZNA
1195 User Manual 1178.6462.02 ─ 12
<Points> Number of sweep points in the segment. See
[SENSe<Ch>:
]SEGMent<Seg>:SWEep:POINts
.
<Power> Internal source power in the segment. See
[SENSe<Ch>:
]SEGMent<Seg>:POWer[:LEVel]
.
Default unit: dBm
<SegmentTime> Duration of the sweep in the segment. See
[SENSe<Ch>:
]SEGMent<Seg>:SWEep:TIME
. In the setting
[SENSe<Ch>:
]SEGMent<Seg>:INSert:SELect DWELl
, this parameter is
replaced by
<MeasDelay>
.
Range: Depending on other channel settings. AUTO acti-
vates automatic sweep time setting in the segment,
which is equivalent to the minimum sweep time
possible.
Default unit: s
<MeasDelay> Delay for each partial measurement in the segment. See
[SENSe<Ch>:]SEGMent<Seg>:SWEep:DWELl
. In the setting
[SENSe<Ch>:]SEGMent<Seg>:INSert:SELect SWTime
,
this parameter is replaced by
<SegmentTime>
.
<Unused> Ignored parameter (for compatibility with R&S ZVR analyzers).
Should be set to the default value 0.
<MeasBandwidth> IF bandwidth in the segment. See
[SENSe<Ch>:
]SEGMent<Seg>:BWIDth[:RESolution]
.
Default unit: Hz
<LO> POSitive | NEGative | AUTO
Position of the local oscillator frequency LO relative to the RF
frequency. In remote control this parameter must be set when a
sweep segment is created.
See
[SENSe<Ch>:]FREQuency:SBANd
.
<Selectivity> NORMal | MEDium | HIGH
Selectivity of the IF filter. See
[SENSe<Ch>:]SEGMent<Seg>:
BWIDth[:RESolution]:SELect
.
<Mode> AUTO
Ignored.
Example: SEGM:INS 1MHZ, 1.5MHZ, 111, -21DBM, 0.5S, 0,
10KHZ
Create a sweep segment with a sweep range between 1.0 MHz
and 1.5 MHz.
SEGM2:ADD
Create a second sweep segment. The frequency range of the
second segment will be between 1.5 MHz and the maximum fre-
quency of the analyzer.
Manual operation: See "Add / Insert / Delete / Delete All" on page 426
SCPI Command Reference