Chapter 2: Rack-Mounting the PDU
4
Mounting Zero U Models Using L-Brackets
If your PDU has circuit breakers implemented, read
Circuit Breaker
Orientation Limitation
(on page 3) before mounting it.
To mount Zero U models using L-brackets:
1. Align the baseplates on the rear of the PX device.
2. Secure the baseplates in place. Use the included L-shaped hex key
to loosen the hex socket screws until the baseplate is "slightly"
fastened.
3. Align the L-brackets with the baseplates so that the five screw-holes
on the baseplates line up through the L-bracket's slots. The
rackmount side of brackets should face either the left or right side of
the PX device.
4. Fasten the brackets in place with at least three screws (one through
each slot). Use additional screws as desired.
Summary of Contents for PX3-4000 series
