Chapter 8: Using the Command Line Interface
482
Example - Setting Up EnergyWise
The following command sets up two Cisco
®
EnergyWise-related features.
config:#
energywise enabled true port 10288
Results:
The EnergyWise feature implemented on the PX is enabled.
The UDP port is set to 10288.
USB-Cascading Configuration Commands
A USB-cascading configuration command begins with
cascading
. You
can set the cascading mode on the master device.
Note: You CANNOT change the cascading mode on slave devices.
Configuring the Cascading Mode
This command determines the cascading mode.
config:#
cascading mode <mode>
Variables:
<mode> is one of the following cascading modes:
Mode
Description
bridging
The network bridging mode, where each
cascaded device is assigned a unique IP
address.
portForwarding
The port forwarding mode, where every
cascaded device in the chain shares the
same IP address, with diverse port
numbers assigned.
Asset Management Commands
You can use the CLI commands to change the settings of the connected
asset sensor (if any) or the settings of LEDs on the asset sensor.
Summary of Contents for PX3-4000 series
