Chapter 8: Using the Command Line Interface
392
Setting EAP Parameters
When the wireless authentication method is set to EAP, you must
configure EAP authentication parameters, including outer authentication,
inner authentication, EAP identity, password, and CA certificate.
Determine the outer authentication protocol:
config:#
network wireless eapOuterAuthentication <outer_auth>
Determine the inner authentication protocol:
config:#
network wireless eapInnerAuthentication <inner_auth>
Set the EAP identity:
config:#
network wireless eapIdentity <identity>
Set the EAP password:
config:#
network wireless eapPassword
After performing the above command, the PX prompts you to enter the
password. Then type the password and press Enter.
Provide a CA TLS certificate:
config:#
network wireless eapCACertificate
After performing the above command, the system prompts you to enter
the CA certificate's contents. For details, see
EAP CA Certificate
Example
(on page 394).
Enable or disable verification of the TLS certificate chain:
config:#
network wireless enableCertVerification <option1>
Allow expired and not yet valid TLS certificates:
config:#
network wireless allowOffTimeRangeCerts <option2>
Allow wireless network connection with incorrect system time:
Summary of Contents for PX3-4000 series
