Raritan PX3-4000 series, User Manual

Page: 43 / 688

Chapter 3: Installation and Configuration
22
Wi-Fi LAN adapter Supported 802.11
protocols
TP-Link TL-WDN3200 v1 A/B/G/N
Raritan USB WIFI A/B/G/N
Note: To use the Edimax EW-7722UnD or Raritan USB WIFI wireless
LAN adapter to connect to an
802.11n
wireless network, the handshake
timeout setting must be changed to 500 or greater, or the wireless
connection will fail.
Supported Wireless LAN Configuration
If wireless networking is preferred, ensure that the wireless LAN
configuration of your PX matches the access point. The following is the
wireless LAN configuration that the PX supports.

Network type: 802.11 A/B/G/N

Protocol: WPA2 (RSN)

Key management: WPA-PSK, or WPA-EAP with PEAP and
MSCHAPv2 authentication

Encryption: CCMP (AES)
Important: Raritan only supports specific wireless LAN adapters.
Supported 802.11 network protocols vary according to the wireless LAN
adapter being used with the PX. See
USB Wireless LAN Adapters (on
page 21).
Initial Network Configuration via CLI
After the PX is connected to your network, you must provide it with an IP
address and some additional networking information.
This section describes the initial configuration via a serial RS-232 or USB
connection.
To configure the PX device:
1. On the computer connected to the PX, open a communications
program such as HyperTerminal or PuTTY.
2. Select the appropriate COM port, and set the following port settings:

Bits per second = 115200 (115.2Kbps)

Data bits = 8

Stop bits = 1

Parity = None