Raritan PX3-4000 series, User Manual

Page: 578 / 688

Appendix F: PX3 Phase I LCD Display
557
Section Information shown
The following information is displayed:
 Readings, data or state of the selected target.
 During the firmware upgrade, 'FUP' is displayed.
Two types of information may be displayed:
 The 'ALARM' status of the selected component.
 The selected inlet line number if your PX is a 3-phase
model.
The measurement unit of the displayed data.
This section indicates:
 The Asset Sensor mode if an asset sensor has been
connected to the PX.
 The device's USB-cascading state -
MASTER
or
SLAVE
. If it is a standalone device, neither MASTER
nor SLAVE is displayed.
Note: During the firmware upgrade, some PX models may show b
x
in the
section 1 to indicate the relay or meter board numbered
x
is being
updated.
Control Buttons
There are four control buttons.
 Up and Down buttons for selecting a specific target, which can be an
inlet, outlet, overcurrent protector, environmental sensor or a device
setting
 MODE button for switching between various modes, including:
- Inlet mode
- Outlet mode
- Overcurrent Protector mode
- Device mode
- Sensor mode
- Asset Sensor mode, indicated by the word ASSET, for showing the
asset sensor information