Raritan PX3-4000 series, User Manual

Page: 44 / 688

Chapter 3: Installation and Configuration
23

Flow control = None
Tip: For a USB connection, you can determine the COM port by
choosing Control Panel > System > Hardware > Device Manager,
and locating the "Dominion PX2 Serial Console" under the Ports
group.
3. In the communications program, press Enter to send a carriage
return to the PX.
4. The PX prompts you to log in. Both user name and password are
case sensitive.
a. Username:
admin
b. Password:
raritan
(or a new password if you have changed it).
5. If prompted to change the default password, follow onscreen
instructions to type your new password.
6. The # prompt appears.
7. Type
config
and press Enter.
8. To configure network settings, type appropriate commands and
press Enter. All commands are case sensitive.
a. To set the networking mode, type this command:
network mode <mode>
where <mode> is
wired
(default) or
wireless
.
b. For the wired network mode, you may configure the LAN
interface settings. In most scenarios, the default setting (auto)
works well and should not be changed unless required.
To set Use this command
LAN interface
speed
network interface
LANInterfaceSpeed <option>
<option> =
auto
,
10Mbps
, or
100Mbps
.
LAN interface
duplex mode
network interface
LANInterfaceDuplexMode <mode>
<mode> =
half
,
full
or
auto
.
Tip: You can combine multiple commands to configure multiple
parameters at a time. For example,
network interface LANInterfaceSpeed <option>
LANInterfaceDuplexMode <mode>
c. For the wireless network mode, you must configure the Service
Set Identifier (SSID) parameter.