Omron CJ Series, Operation Manual

Page: 339 / 415

7-6 Editing Master Unit Parameters
7-6-1 Master Unit Parameter Settings
7-18
7-6 Editing Master Unit Parameters
Edit Master Unit parameter settings as needed. For details on Unit parameter settings,
refer to the Unit manual.
This section describes the setting parameters for an OMRON CompoNet Master Unit.
7-6-1 Master Unit Parameter Settings
The settable Master Unit parameters are listed in the following table.
Tab page Setting Description
Function Choice Sets communications settings.
Registration Table Displays the Registration Table Tab
Page.
Software Setting Table Displays the Software Setting Table Tab
Page.
General
Transfer/Compare Performs uploading, downloading, and
comparison of parameters between the
computer and components.
Unregistered/
Registered Device List Sets the Slave Units that will join the
network. Registration Table
(See note.)
Advanced Setting Sets the conditions for the Slave Units
that will join the network.
Data Software Setting
Table (See note.)
Participation
Flag/Communications Error
Flag
User-defined areas can be allocated to
the Slave Units and error flags.
Note: Displayed only when Registration Table and Software Setting Table are enabled on
the General Tab Page.
Parameter Setting Procedure
1. Connect online to the actual CompoNet Network, and upload the network
configuration to the computer. Alternatively, the network configuration can be
read from a CX-Integrator project file.
2. From the Network Configuration Window, double-click the Master Unit, or right
click it and select Parameter - Edit from the menu. (Alternatively, select
Parameter - Edit from the Component Menu.)
Double-click, or right-click and select
Parameter – Edit .
The Master Unit Parameter Settings Dialog Box will be displayed.
The contents of each tab page are shown next. For details on parameter settings, refer
to the Master Unit manual.