Omron CJ Series, Operation Manual

Page: 326 / 415

7-3 Uploading, Downloading, and Comparing Network Configurations
7-3-1 Upload the Network Configuration to the Computer
7-5
7-3 Uploading, Downloading, and Comparing
Network Configurations
The configuration of the actual network can be written to a virtual network on the
CX-Integrator running on the computer. Network configurations will also be compared.
This section describes how to perform each task.
7-3-1 Upload the Network Configuration to the Computer
Use the following procedure to read the network configuration information from the
network.
1. While online, right-click the Master Unit under the connected PLC in the Online
Connection Information Window, and then select Connect .
2. Right-click the Master Unit, and then select Transfer [Network to PC] .
The Transfer [Network to PC] Dialog Box will be displayed.
Data Description
Network structure only Uploads the network structure to the computer.
Network structure and
parameters for each component Uploads the network configuration and
parameters for each component to the
computer.
Master only (including
parameters) Uploads the Master Unit and Master Unit
parameters on the network configuration to the
computer.
Note Approximately 15 seconds is required per node to transfer parameters. If the network
structure and parameters for each component are selected, up to 100 minutes may be
required to complete the transfer.
3. Select the data to be uploaded and click the Transfer Button.
The network configuration that was sent to the computer will be displayed in the
Network Configuration Window.