Omron CJ Series, Operation Manual

Page: 226 / 415

4-3 Manually Setting Data Links
4-3-11 Transferring the Data Link Table
4-37
Note:
As long as all the data link tables can be transferred to all of the PLCs attempted,
Set All Nodes for Network Operation can be selected to transfer the data link tables
simultaneously to multiple PLCs. If there are any PLCs with the power turned OFF,
or with disconnected cables, use the following method to transfer the data link table
to one PLC at a time.
Transferring to Individual Nodes on the Network
1 Make sure that Set All Nodes for Network Operation is not selected in the Online
Menu.
Confirm that there is no
check mark.
2 Select the transfer destination node address from the Node list in the Datalink
Component.
3 Select Online - Transfer to PLC . The following dialog box will be displayed.
Final confirmation of link table
transfer nodes (PLCs)
3 Click the Yes Button.
4 The data link tables will be transferred to node 2.
5 The transfer results will be displayed. Click the
OK Button.
The following dialog box for confirming data link modes will be displayed when the
OK
Button is clicked after completing data link table transfer using CX-Integrator version
2.0 or higher for a Controller Link Network.
1. Click the Yes Button to confirm the data link mode settings.
The data link mode setting will be read from all nodes on the network.