Sensors
Figure 7.2: The password request for sensor parameters
NOTE!
For control panel CP4000 with LCD the protection is implemented as
disabled Apply menu item. In this case it is imposseible to change the
values.
7.2.3
Sensor Softkey and Indicators
There is a sensor softkey for each of the sensors. Using this softkey the operator defines a state of a sensor and operates
it.
In addition, each sensor is shown with different indicators that display the status of the data transmitted by the sensor
and their filter. These indicators are: Data indicator, Data filter indicator and Preferred sensor indicator.( Figure 7.3)
Figure 7.3: Sensor softkey with indicators
7.2.4
Sensor Softkey
A sensor’s name is the title of the proper sensor softkey.
Use the sensor softkey to operate a sensor.
Press a sensor softkey to get the following dialog box for the specified sensor (see Figure 7.4). The softkey of the
current usage state is white-colored.
Not Use
— select this item if the sensor does not work properly or is not installed yet;
Monitor
— select this item if you want to turn off the sensor temporarily;
Select
— press to select the sensor;
Cancel
— press to exit the dialog box without any changes.
The color of the sensor softkey shows the state of the sensor as described below:
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
128
