DPShell Service Utility
Bind DPShell to CP
command binds
DPShell
to the control panel on this control station:
– to enter
DPShell
you should not switch the panel into “Service Mode”;
– connection to
DPShell
will appear in the list of panel active connections.
This operation may take up to several minutes.
Unbind DPShell from CP
command cancels
DPShell
binding to the control panel:
– if you entered
DPShell
utility in “Operation Mode”, then “Connection with control panel will be closed,
proceed?” message will appear (see Figure G.24);
Figure G.24: Unbind DPShell from CP. Confirmation
– after you press “YES” the connection will be closed. To enter
DPShell
next time you should switch the
control panel into “Service Mode” (see Section 5.12.6, page 99).
Rebind DPShell to CP
command binds
DPShell
to the control panel as the command “Bind DPShell to CP” does.
“Rebind...” means that
DPShell
utility has been already bound to another panel on ths control station.
Info
— displays current system information (see Figure G.25).
Figure G.25: DPShell. Obtaining System information
Return
— back to level up.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
318
