NAVIS NavDP 4000. Operation Manual
– motion along the time axis by using arrows:
— back,
— forward.
Figure H.19: Service Softkeys
Record information is also displayed at the bottom side of the screen.
When particular record is selected, information concerning this record (start/stop time and duration) is displayed.
softkey allows increasing the time range for the analyzed records, but no more than 12 hours.
H.4.3
Operation with Charts
Chart windows contain the following softkeys (may vary for different chart types):
(
Plot/Table Settings
) softkey is used for selecting/changing plot settings:
– press “Plot/Table Settings” softkey and wait for either “Time series plot” or “Position plot” window will appear
(it depends on the chart type);
– tick the boxes of required items for the plot (for detailed description of the plot parameter selecting see Section
– press “OK”;
– the chart will be plotted according to selected parameters in the window.
(
Statistic
) softkey is used for displaying min, max, avg and median values.
(
Change angle range
) softkey is used for changing axis angle from 0 to 360
0
(0, 180 or 360
0
).
(
Move
) softkey is used for chart moving (up/down) and swapping (left/right) (see Figure H.20).
Figure H.20: Move/Swap Softkey
(
Minimize
) softkey is used for minimizing of the chart window.
(
Expand
) softkey is used for expanding of the chart window.
(
Close
) softkey is used for closing of the chart window.
Press the Chart Name to hide/show or remove the chart.
If several charts are plotted in a one window and all the chart names cannot be placed in the line,
softkey becomes
active. When you press this softkey the other chart names are shown.
335
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
