Operator Interface
UTM
The UTM coordinate system. To show/hide this option, change “Use UTM” parameter in Coord page of
Param window.
Trace selection
Use the appropriate softkey to select Trace ON or Trace OFF mode.
The current mode is displayed on the softkey:
Trace ON
The vessel trace is displayed with white points on the screen (the trace of the center of rotation).
Trace OFF
The vessel trace is not shown on the screen.
Figure 5.14: Trace Points Example
The vessel trace is shown on the screen according to Step and History settings for the vessel trace. These settings
are made by the operator in
View
page of
Param
window (see Section 5.9, page 85).
View selection
Use the appropriate softkey to select the Map representation:
– in absolute coordinates
– in relative coordinates
The current mode is displayed on the softkey:
View: TRUE
The map is shown in the earth fixed coordinates.
View:REL
The map is shown in the vessel fixed coordinates.
Figure 5.15: View: true and relative
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
74
