System Functions
Figure 10.42: Goto WP dialog
Latitude, Longitude/ Course, Distance
— the coordinates of the waypoint;
NOTE!
A coordinate system is selected in Coord page of Param window.
R, m
— the turning radius;
V, m/s
— the vessel speed between selected point and the next one;
HDG
— heading during the passing of the leg;
/
— strategy of the waypoint passing.
NOTE!
In case LS Track (HS Track) mode is not activated none of waypoints
is highlighted in the Waypoint table.
If there is no active route the table is empty.
The operator can choose the next waypoint by pressing
Goto WP
softkey (see Figure 10.42.
In particular, it is possible to go to the next waypoint having passed several intermediate ones.
10.6.3.4
Waypoint Motion Control Console
In case of any Track mode (LS Track, HS Track) is on, the bottom section of the window displays the following
parameters:
At the bottom of the window the information about the waypoint specifies (see Figure 10.43):
State
of track mode:
Not Active
— LS (or HS) Track mode is not selected;
Following
— LS (or HS) Track mode is activated;
Paused
— LS (or HS) Track mode is paused.
When following the track the operator can change the state from
Following
to
Paused
.
Press the softkey
LS Track/HS Track
on POS (HDG) panel to change a track mode state.
In the opened dialog window press either
OK
softkey to approve the changes or
Cancel
to leave the window without
any changes.
The text of the dialog window depends on the current track mode state (see Figure 10.44.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
198
