System Functions
Figure 10.39: Load Route Dialog
NOTE!
Keep in mind that after the
Unmount
softkey is pressed, the USB flash
drive is not visible for the system. To make it visible, remove the device
and then insert in again.
Load
NOTE!
This function is available for the DP routes only. It does not support
external route formats.
The route saved before can be loaded into the DP system.
Insert the external device (USB flash drive) and press the
Load
softkey. The
Load DP Routes
dialog appears (see
Figure 10.39).
The file name (route name) and the number of waypoints are displayed for every route.
When route is selected it is automatically displayed on the map (in the MAP window), but keep in mind that only the
waypoints with coordinates inside the visible area are displayed.
The route is added to the list just after the
Load
softkey is pressed.
10.6.3.2
The Track Following/Alarm Parameters (Param)
The two parameter groups are available in this mode (see Figure 10.40):
– Track;
– Alarm.
The mode is used to set up both the LS Track and HS Track.
For more LS Track details see the Section 9.2.6, page 164 and HS Track details see the Section 9.2.5, page 163.
Set the parameters of tracking in the “Track Following Parameters” window (“Track” softkey):
– Along Speed Source (manual, joystick or table);
– Along Speed Manual, m/s;
– Turn Radius Source (manual or table);
– Turn Radius Manual, m;
– WP Pass Stategy (non stop or stop);
– End of Track Strategy (resume or stop);
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
196
