Operator Interface
– Sensors View;
– Thruster View;
– REF View;
– Power View (if available);
– System views.
The Main View also is used to display the control position dialog window.
5.12.1.1
Alarm List View
To switch to the Alarm List View press the “ALARM LIST” pushbutton (see 2.4.18, page 32). The view contains the
entire list of the DP alarm messages.
Additionally the last message is displayed in the top alarm bar.
5.12.1.2
Auto Pilot View
Operating in the autopilot mode (AP) main view contains the following information (see Figure 5.42):
– The current heading;
– The heading set;
– The current angular velosity;
– The current speed (SOG);
– The heading set offset.
Figure 5.42: AP Mode
NOTE!
The AP View is the view title and doesn’t mean the AP mode
In DP mode the displayed information depends on settings. In case of the AutoHDG mode the heading and the current
speed are displayed (see Figure 5.43).
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
92
