Mitsubishi Electric GT15, Connection Manual

Page: 384 / 864

10 - 16
10. MELSECNET/10 CONNECTION (PLC TO PLC NETWORK)
10.4 PLC Side Setting

Parameter setting (when connecting to C
Controller module (Q Series))
Use SW3PVC-CCPU-E Ver.3.05F or later for the
MELSECNET/H utility.
(1) Connection settings
: Necessary : As necessary : Not necessary
*1 If the IP address of the C Controller module (Q Series) has
been changed, input the changed IP address or host name.
*2 If the account of the C Controller module (Q Series) has
been changed, input the changed user name and password.
(2) MELSECNET/H Utility's [Parameter Settings]
(a) Parameter settings
: Necessary : As necessary : Not necessary
*1 Specify the same network No. as that of the GOT.
*2 Be sure to set the setting to perform the cyclic transmission.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the C Controller
module (Q Series), either turn the C Controller module
(Q Series) OFF and then ON or reset it.
Item Set value
Setting
necessity at
GOT connection
Target module
*1
192.168.3.3 (Default)
Write authority Mark the checkbox
User name
*2
target
Password
*2 password
Detailed settings -
Item Set value
Setting
necessity at
GOT connection
Number of modules 1
Link device refresh cycle (Use default value)
Routing parameter Refer to (b).
Target module 1
Start I/O No. 0000
H
Channel No. (Use default value)
Item Set value
Setting
necessity at
GOT
connection
O
pera
tio
n set
tings
Network type
MNET/10 mode
(Control station)
Network No.
*1
1
Group No. 0
Mode Online
Return (Use default value)
Refresh parameters (Use default value)
Netwo
rk ra
nge
assignmen
t
Total stations 2
Assignment method Start/End
LB
/L
W se
tt
ing
s
*2
Sen
d rang
e
for
each st
at
ion
LB
Sta.
No.1
Start 0000
H
End 00FF
H
Sta.
No.2
Start 0100
H
End 01FF
H
Sen
d r
ange
f
or
ea
ch
st
at
ion
L
W
Sta.
No.1
Start 0000
H
End 00FF
H
Sta.
No.2
Start 0100
H
End 01FF
H
(LX/LY) settings
*2
No setting
Monitoring time (Use default value)
Specify I/O master Sta.
*2
No setting
Specify reserved Sta. No setting
Supplementary settings (Use default value)