Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 968 / 1218

CC-Link IE Field Network (FR-A800-GF) Parameters
5 - 766
Programming example for the parameter writing
The following program changes the setting value in Pr. 7 "Acceleration time" of the station 1 inverter
to 3.0 s.
●
Acceleration time writing instruction code: H87 (hexadecimal)
●
Acceleration time setting data: K30 (decimal)
For the details of instruction codes of each parameter, refer to the list of parameters (function codes)
and instruction codes under different control methods on page A-5.
The reply code (RWr10) to the instruction code execution is set in D2.
(Refer to page 5-756 for the reply code (RWr10).)
I003089E
Fig. 5-379: Programming example 5
NOTES For the parameter assigned the number of 100 or higher, change the link parameter extended set-
ting (set it to the one other than H00). Refer to page A-5 for the settings.
For other functions, refer to the instruction codes on page 5-757.
SET M301
PLS M300
MOV W10 D2
MOV H87 W110
SET Y1025
0
3
7
9
18
24
M0 X20
X1025 M301
SB49
X1025
M300
SET M302
M302
RST Y1025
RST M302
END
MOV K30 W111
RST M301
M0
SW0B0.0
Check the data link status of the station 1.
Read the reply code (RWr10) to output to D2 when the instruction code
execution completion (RX25) turns ON.
Write the Pr. 7 write code (H87) to RWw10 and the acceleration time
setting data (K30) to RWw11.
Turn OFF the instruction code execution request (RY25).
Turn ON the instruction code execution request (RY25).