Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 915 / 1218

Parameters (G) Control parameters
FR-A800 5 - 713
5.16.10 Regenerative brake selection and DC feeding mode
●
When performing frequent start and stop operation, usage rate of the regenerative brake can be
increased by using the optional high-duty brake resistor (FR-ABR) or the brake unit (FR-BU2, BU,
FR-BU).
●
When using continuously in regenerative condition, use the power regeneration common con-
verter (FR-CV) or power regeneration converter (MT-RC). The high power factor converter
(FR-HC2) can be used also to reduce harmonics, improve power factor, and operate continuously
in the regenerative status.
●
It is possible to choose between the DC feeding mode 1, which will operate with DC power supply
(terminals P and N), and DC feeding mode 2, which will normally operate in AC power supply
(terminals R, S, and T) and operate in DC power supply (terminal P and N), such as batteries, at the
time of power failure.
●
While the power is supplied only to the control circuit, the reset operation when the power is
supplied to the main circuit can be selected.
The initial value or setting range for the standard model
The initial value or setting range for the separated converter type
The initial value or setting range for the IP55 compatible model
Available only with the standard model
Pr. Name
Initial
value
Setting
range
Description
30
E300
Regenerative function
selection
0
10
0 to 2, 10,
11, 20, 21,
100 to 102,
110, 111,
120, 121
First digit: Regeneration unit selection ("0" for built-in brake,
"1" for high-duty brake resistor, "2" for FR-HC2 or FR-CV)
Second digit: Selection of the power supply terminal to the
inverter ("0" for AC, "1" for DC, "2" for AC and DC)
Third digit: Reset when the power is supplied to the main
circuit ("0" for reset, "1" for no reset)
For details, refer to the table below.
2, 10, 11,
102, 110,
111
0, 2, 10, 20,
100, 102,
110, 120
70
G107
Special regenerative
brake duty
0% 0 to 100% Set the %ED of the built-in brake transistor operation.
599
T721
X10 terminal input
selection
0
1
0 Normally open input
1 Normally closed input (NC contact input specification)