Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 641 / 1218

Parameters (T) Multi-Function Input Terminal Parameters
FR-A800 5 - 439
5.12.8 Input terminal function selection
Use the following parameters to select or change the input terminal functions.
The initial value is for standard models and IP55 compatible models.
The initial value is for separated converter types.
Pr. Name
Initial
value
Initial signal Setting range
178
T700
STF terminal function
selection
60 STF (Forward rotation command)
0 to 20, 22 to 28, 37, 42 to 48,
50 to 53, 57 to 60, 62, 64 to
74, 76, 77 to 80, 87, 92 to 96,
9999
179
T7001
STR terminal function
selection
61 STR (Reverse rotation command)
0 to 20, 22 to 28, 37, 42 to 48,
50 to 53, 57 to 59, 61, 62, 64
to 74, 76, 77 to 80, 87, 92 to
96, 9999
180
T702
RL terminal function
selection
0
RL (Low-speed operation
command)
0 to 20, 22 to 28, 37, 42 to 48,
50 to 53, 57 to 59, 62, 64 to
74, 76, 77 to 80, 87, 92 to 96,
9999
181
T703
RM terminal function
selection
1
RM (Middle-speed operation
command)
182
T704
RH terminal function
selection
2
RH (High-speed operation
command)
183
T705
RT terminal function
selection
3 RT (Second function selection)
184
T706
AU terminal function
selection
4 AU (Terminal 4 input selection)
185
T707
JOG terminal function
selection
5 JOG (Jog operation selection)
186
T708
CS terminal function
selection
6
CS (Selection of automatic restart
after instantaneous power failure,
flying start)
187
T709
MRS terminal function
selection
24
MRS (Output stop)
10
X10 (Inverter run enable signal)
188
T710
STOP terminal function
selection
25
STP (STOP) (Start self-holding
selection)
189
T711
RES terminal function
selection
62 RES (Inverter reset)
Pr. Name
Initial
value
Setting range Description
699
T740
Input terminal filter 9999
5 to 50 ms
Set the time to delay the input terminal
response.
9999 No input terminal filter
NOTES Using the SOURCE/SINK jumper (and the particular connection of the PC/SD terminal as a refer-
ence point), the input terminals can be changed between positive switching (source logic) or neg-
ative switching (sink logic) depending on regional requirements.
Connection diagrams in this Instruction Manual appear with the control logic of the input terminal
as source logic, unless otherwise specified. (For the control logic, refer to page 2-49.)