Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 756 / 1218

(A) Application parameters Parameters
5 - 554
PID output suspension function (SLEEP function) (SLEEP signal, Pr. 575 to Pr. 577)
●
When a status where the output frequency after PID calculation is less than Pr. 576 "Output
interruption detection level" has continued for the time set in Pr. 575 "Output interruption
detection time" or longer, inverter running is suspended. This allows the amount of energy
consumed in the inefficient low-speed range to be reduced.
●
When the deviation (for instance, the set point - measured value) reaches the PID output shutoff
release level (Pr. 577 setting value -1000%) while the PID output suspension function is activated,
the PID output suspension function is released, and PID control operation is automatically
restarted.
●
Whether to allow motor to coast to a stop or perform a deceleration stop when SLEEP operation
is started can be selected using Pr. 554.
●
While the PID output suspension function is activated, the PID output interruption signal (SLEEP)
is output. During this time, the inverter running signal (RUN) turns OFF and the During PID control
activated signal (PID) turns ON.
●
For the terminal used for the SLEEP signal, set "70 (positive logic)" or "170 (negative logic)" in any
of Pr. 190 to Pr. 196 (output terminal function selection).
I002693E
Fig. 5-269: Output interruption (SLEEP function)
RUN
SLEEP
PID
1000%
When Pr. 554 = "0 to 3", reverse operation (Pr. 128 = "10")
Deviation
Pr. 577
Output frequency
Pr. 576
Less than Pr. 575
Pr. 575 or more
SLEEP period
OFF
ON
Time
Cancel
level