Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 769 / 1218

Parameters (A) Application parameters
FR-A800 5 - 567
●
The pre-charge function valid/invalid settings and pre-charge ending conditions are as follows:
When two or more ends conditions are satisfied, the pre-charge operation ends by the first-
satisfied condition.
Pr. 127 setting
Pre-charge ending condition setting
Pre-charge
function
Valid pre-charge ending
condition
Pr. 761 setting Pr. 762 setting X77 signal
9999
⎯ ⎯ ⎯
Disabled
⎯
Other than 9999
9999
9999
Not assigned
Assigned
Enabled
⎯ ⎯
X77
Other than 9999
Not assigned
⎯
Time
⎯
Assigned
⎯
Time X77
Other than 9999
9999
Not assigned Result
⎯ ⎯
Assigned Result
⎯
X77
Other than 9999
Not assigned Result Time
⎯
Assigned Result Time X77
Tab. 5-238: Settings of the pre-charge function
NOTES During the pre-charge operation, it is regarded as integrated value=estimated value. The motor
speed may drop shortly from the automatic switchover frequency depending on the parameter
settings.
Parameter changes and switchover to the second PID control are applied immediately. If PID con-
trol has not started when the settings were changed, PID control starts with changed settings. (If
PID control has already started, these settings do not apply. If the changed settings already satis-
fies a condition to start PID control, the PID control starts as soon as these are changed.)
The pre-charge also ends when PID control is set to invalid, the start command has been turned
OFF, and output has been shut off.