Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 548 / 1218

(M) Monitor display and monitor output signal Parameters
5 - 346
Load meter 0.1% 17 H11 40217
Displays torque current as a
percentage, considering Pr. 56
setting value as 100% (motor
rated torque is considered as
100% during Sensorless vector
and vector control).
Motor excitation
current
%
0.01 A/
0.1 A
$
18 H12 40218
Displays the motor excitation
current
Position pulse
( ⎯
19 H13 40219
Displays the number of pulses
per motor rotation during
orientation control and position
control. (Displays the voltage
monitor when a vector control
compatible option is not
connected.)
Cumulative
energization
time
1 h 20 H14 40220
Displays the cumulative
energization time since the
inverter shipment.
Check how many times the
monitor value exceeded 65535 h
with Pr. 563.
Orientation
status
(
1 22 H16 40222
Displays values only when
orientation control is enabled.
(Displays the voltage monitor
when a vector control
compatible option is not
connected.)
(Refer to page page 5-522)
Actual operation
time
1 h 23 H17 40223
Displays the cumulative time
since the inverter began running.
The number of times the monitor
value exceeded 65535 h can be
checked with Pr. 564.
This can be cleared with Pr. 171.
(Refer to page 5-354)
Motor load
factor
0.1% 24 H18 40224
Displays the output current
value as a percentage,
considering the inverter rated
current value as 100%.
Monitor value = output current
monitor value / inverter rated
current × 100 [%]
Cumulative
power
%
0.01 kWh/
0.1 kWh
$
25 H19 40225
Displays the cumulative energy
based on the output power
monitor.
This can be cleared with Pr. 170.
(Refer to page 5-354.)
Position
command
(lower digits)
1 26 H1A 40226

Displays the position command
(decimal) before the electronic
gear is set.
*
Position
command
(upper digits)
1 27 H1B 40227

Current position
(lower digits)
1 28 H1C 40228

Displays the value of the position
feedback pulse after converting
it into the number of pulses
before the electronic gear is set.
*
Current position
(upper digits)
1 29 H1D 40229

Droop pulse
(lower digits)
1 30 H1E 40230

Displays the droop pulse before
the electronic gear.
*
Droop pulse
(upper digits)
1 31 H1F 40231

Torque
command
0.1% 32 H20 40232

Displays the torque command
value obtained from the vector
control results.
Types of
monitor
Unit
Pr. 52,
Pr. 774 to Pr. 776,
Pr. 992
RS-485
communica-
tion dedicat-
ed monitor
(hexadeci-
mal)
Modbus®
RTU real
time
monitor
Minus (-)
display
Description
Tab. 5-130: Monitor description list (2)