Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 789 / 1218

Parameters (A) Application parameters
FR-A800 5 - 587
Restart at every start (Pr. 162 = "10 to 13")
When "10 to 13" is set in Pr. 162, a restart operation is performed at each start and automatic restart af-
ter instantaneous power failure (Pr. 57 start after the reset time has elapsed). When "0 (initial value) to
3" is set in Pr. 162, a restart operation is performed at the first start after a power-ON, and from the sec-
ond power-ON onwards, a start from the starting frequency is performed.
Automatic restart operation of MRS (X10) signal
The restart operation after restoration from output shutoff by the MRS (X10) signal is as shown in the
table below according to the Pr. 30 setting.
NOTES If "2, 12" are set to Pr. 162 when encoder feedback control is invalid, the automatic restart is with a
frequency search (Pr. 162 = "0, 10").
In vector control, encoder detection frequency search is used regardless of the Pr. 162 setting. The
Pr. 58 and Pr. 299 settings are invalid at this time.
For the encoder feedback control, refer to page 5-730.
Pr. 30 setting Operation after restoration from output shutoff by the MRS (X10) signal
2, 10, 11, 102, 110, 111 Restart operation (starting from the coasting speed)
Other than the above Starting from Pr.13 Starting frequency.
Tab. 5-249: Operation selection after output shutoff
NOTES When output is shut off using safety stop function (terminals S1 and S2), the inverter restarts in the
same way as when output is shut off by MRS (X10) signal.